Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Side Door Wiring Harness Replacement

Preliminary Procedure

Preliminary Procedure

Remove the rear side door inner panel trim. Refer to Rear Side Door Trim Replacement.

  1. Rear Side Door Wiring Harness

Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

For Vehicles equipped with OnStar® (UE1) with Back Up Battery: The Back Up Battery is a redundant power supply to allow limited OnStar® functionality in the event of a main vehicle battery power disruption to the VCIM (OnStar®module). Do not disconnect the main vehicle battery or remove the OnStar® fuse with the ignition key in any position other than OFF. Retained accessory power (RAP) should be allowed to time out or be disabled (simply opening the driver door should disable RAP) before disconnecting power. Disconnecting power to the OnStar® module in any way while the ignition is On or with RAP activated may cause activation of the OnStar® Back-Up Battery (BUB) system and will discharge and permanently damage the back-up battery. Once the Back-Up Battery is activated it will stay on until it has completely discharged. The BUB is not rechargeable and once activated the BUB must be replaced.

Procedure

  1. Disconnect the battery.
  2. Remove the water deflector.
  3. Disconnect electrical connectors as needed.
Front Side Door Wiring Harness Replacement
Preliminary Procedure Remove the front side door inner panel trim. Refer to Front Side Door Trim Replacement. Front Side Door Wiring Harness Warning: Unless directed otherwise, the ignition a ...

Hood Primary Latch Release Cable Handle Replacement
Preliminary Procedure Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement. Hood Primary Latch Release Cable Handle Procedure Pull down the hoo ...

Other materials:

Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of ...

Power Windows Description and Operation
Power Windows System Components The power window system consists of the following components: Driver window switch Passenger window switch Left rear window switch Right rear window switch Window motors in each of the doors F24UA 30A Fuse F55UA 7.5A Fuse F21UA 7.5A Fuse Body cont ...

Securing Child Restraints (Front Passenger Seat)
This vehicle has airbags. A rear seat is a safer place to secure a forward-facing child restraint. In addition, the vehicle has a passenger sensing system which is designed to turn off the right front passenger frontal airbag and passenger knee airbag under certain conditions. A label on the ...

© 2011-2024 Copyright www.ccruze.com