If there is a decrease in the RKE operating range: • Check the distance. The transmitter may be too far from the vehicle.
• Check the location. Other vehicles or objects may be blocking the signal.
• Check the transmitter's battery.
See “Battery Replacement” later in this section.
• If the transmitter is still not working correctly, see your dealer or a qualified technician for service.
Keys
Remote Keyless Entry (RKE) System OperationFront Wheel Drive Shaft Replacement - Left Side
Special Tools
CH-313 Slide Hammer
CH-6003 Axle Shaft Remover
CH-46376 Holding Wrench
CH-49400 Hub Spindle Remover
DT-6332 Seal Protector
EN-956-1 Extension
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: To prevent personal injury and/or component ...
Installation Procedure
Remove the front wheelhouse rear panel brace (1) from service panel.
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges
of the front wheelhouse (1).
Clean and prepare the attaching surfaces for brazing.
Note: In MIG-brazing areas 50 mm (2 in) must b ...
Lamp Messages
AUTOMATIC LIGHT CONTROL ON
This message is displayed when the automatic light control has been turned on.
AUTOMATIC LIGHT CONTROL OFF
This message is displayed when the automatic light control has been turned off.
XXX TURN INDICATOR FAILURE
When one of the turn signals is out, this message disp ...