Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR   Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the front hinge pillar body.

Note: Do not damage any inner panels or reinforcements.

Note: Do not damage any inner panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Locate and mark all the necessary factory welds of the front hinge pillar body.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly

  1. Remove the damaged  front hinge pillar body.
Front Hinge Pillar Body Sectioning (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed ...

Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Other materials:

Horns
Specifications Horn Replacement Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Horn Nut Caution: Refer to Fastener Caution in the Preface section. Tighten 17 N·m (13 lb ft) Horn Tip Disconnect electrical connectors. St ...

Cooling System
The cooling system allows the engine to maintain the correct working temperature. 1.4L L4 Engine Shown, 1.8L L4 Engine Similar 1. Engine Cooling Fan (Out of View) 2. Engine Coolant Surge Tank and Pressure Cap WARNING An electric engine cooling fan under the hood can start up even when the eng ...

Rear Compartment Lid Hinge Torque Rod Replacement
Preliminary Procedure Remove rear compartment lid. Refer to Rear Compartment Lid Replacement. Special Tools BO-125 Torque Rod Lifter For equivalent regional tools, refer to Special Tools. Rear Compartment Lid Hinge Torque Rod - Right Side Tip Only use the special tool to remove and i ...

© 2011-2024 Copyright www.ccruze.com