Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR   Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  6. Locate and mark all factory welds.

  1. Drill all factory welds lower. Note the number and location of welds for installation of the service assembly.

  1. Drill all factory welds upper. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged body lock pillar inner panel.
Body Lock Pillar Inner Panel Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted    from the original panel. Clean and prepare the attaching surfaces for welding. ...

Other materials:

Courtesy/Illuminated Entry Lamps
The following lamps may be manually turned ON by placing the interior lamp switch in the ON position, or by opening a door while the switch is in the AUTO position. The dome lamp The liftgate lamps Courtesy lamps The courtesy lamp supply voltage circuit of the body control module (BCM) ...

Engine Compartment Overview
1.4L L4 Engine   1. Engine Air Cleaner/Filter 2. Engine Oil Dipstick. 3. Engine Cooling Fan (Out of View). 4. Engine Oil Fill Cap. 5. Remote Negative (-) Grounding Point. 6. Brake/Clutch Fluid Reservoir. 7. Battery 8. Engine Coolant Surge Tank and Pressure Cap. 9. Remote Positive (+ ...

Park Brake and P (Park) Mechanism Check
WARNING When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move. Park on ...

© 2011-2024 Copyright www.ccruze.com