Chevrolet Cruze Repair Manual: Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
- Disable the SIR System. Refer to SIR Disabling and Enabling.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove all related panels and components.
- Visually inspect the damage. Repair as much of the damage as possible.
- Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
- Locate and mark all the necessary factory welds of the body rear end panel.
Note: Note the number and location of welds for installation of the service assembly.
- Drill all factory welds.
- Remove the body rear end panel.
Body Rear End Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed. ...
Installation Procedure
Clean and prepare the attaching surfaces for welding.
Apply structural adhesive to the attaching surfaces.
Position the body rear end panel on the vehicle.
Verify the fit of the body ...
Other materials:
Infotainment
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs
appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET,
the CHEVROLET Emblem, CRUZE, and the CRUZE logo are trademarks and/or service marks
of General Motors LLC, its subsidiaries, a ...
Doors
Trunk
WARNING
Exhaust gases can enter the vehicle if it is driven with the liftgate, trunk/hatch
open, or with any objects that pass through the seal between the body and the trunk/hatch
or liftgate. Engine exhaust contains carbon monoxide (CO) which cannot be seen or
smelled. It can cause u ...
Generator Air Conditioning Compressor,Power Steering Pump Belt Replacement
Removal Procedure
Raise the vehicle full height. Refer to Lifting and Jacking the Vehicle.
Remove the front compartment splash shield. Refer to Front Compartment
Splash Shield Replacement.
Rotate the drive belt tensioner bolt (2) clockwise.
Remove the drive belt (1) while pullin ...
