Chevrolet Cruze Repair Manual: Removal Procedure
- Remove the drivetrain and front suspension frame. Refer to Drivetrain and Front Suspension Frame Replacement.
- Mark Installation position of insulator (2) at frame (1).
- Cut out frame insulator core (1) from frame insulator (2).
Note: On the rear insulator drill holes into the rubber in order to gain free access for jigsaw.
- Remove frame insulator core (1) from outer frame insulator (2).
- Cast out frame insulator (3) from drivetrain and front suspension frame (1) with CH-48377-1 chisel (2).
Drivetrain and Front Suspension Frame Insulator Replacement
Special Tools
CH 49460-1 Adapter
CH 49460-2 Adapter
CH 6616 Hydraulic Hand Pump
CH 6615-10 Hydraulic Cylinder
CH-48377-1 Chisel
For equivalent regional tools. Refer to Special Tools. ...
Installation Procedure
Install the following components on the drivetrain and front suspension
frame:
CH 49460-1 adapter (2).
CH 49460-2 adapter (4).
CH 6615-10 hydraulic cylinder (1).
NEW frame insula ...
Other materials:
Door Locks
WARNING
Unlocked doors can be dangerous.
• Passengers, especially children, can easily open the doors and fall out of
a moving vehicle. The chance of being thrown out of the vehicle in a crash is increased
if the doors are not locked. So, all passengers should wear safety belts properly
and ...
Instrument Panel Upper Compartment Replacement
Instrument Panel Upper Compartment Screw (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Procedure
Before removing the instrument panel upper compartment screws, remove mat.
Tighten
2.5 N·m (23 lb in)
Instrument Panel Upper Compartment Assembly
...
Front Side Door Window Replacement
Preliminary Procedure
Position the window approximately half way down in the door.
Remove the water deflector. Refer to Front Side Door Water Deflector
Replacement.
Remove the outer sealing strip. Refer to Front Side Door Window Outer
Sealing Strip Replacement.
Fr ...
