Chevrolet Cruze Repair Manual: Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the brake rotor. Refer to Front Brake Rotor Replacement.
- Remove the wheel speed sensor screw (2).
- Remove the wheel speed sensor (1) from the steering knuckle.
- Remove the wheel drive shaft from the front wheel bearing/hub. Refer to front wheel drive shaft replacement Front Wheel Drive Shaft Replacement - Left Side and/or Front Wheel Drive Shaft Replacement - Right Side.
- Remove and discard the front wheel bearing/hub bolts (1).
- Remove the front wheel bearing/hub (1) and front brake shield (2) from the steering knuckle.
Front Wheel Bearing and Hub Replacement
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools. ...
Installation Procedure
Position the front brake shield (2) and front wheel bearing/hub (1)
assembly in the steering knuckle.
Caution: Refer to Fastener Caution in the Preface section.
Install the NEW fr ...
Other materials:
General Plastic Repair
Warning: In order to reduce the risk of personal injury when exposed
to toxic fumes while grinding, cutting, or applying repair material on
any type of sheet molded compound or RIM rigid plastic, observe the following
guidelines:
Work in a properly ventilated area
Apply protective cream t ...
Airbag Readiness Light
This light shows if there is an electrical problem with the airbag system. The
system check includes the airbag sensor(s), passenger sensing system, the pretensioners,
the airbag modules, the wiring, and the crash sensing and diagnostic module.
The airbag readiness light comes on for several ...
Towing Equipment
Hitches
Use the correct hitch equipment.
See your dealer or a hitch dealer for assistance.
• The rear bumper on the vehicle is not intended for hitches. Do not attach
rental hitches or other bumper-type hitches to it. Use only a frame-mounted hitch
that does not attach to the bumper.
• ...
