Chevrolet Cruze Repair Manual: Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
Note: DO NOT re-use the lower control arm bolts and nuts. Discard and use NEW only.
- Remove wheel speed sensor wiring harness from control arm and steering knuckle.
- Remove and DISCARD the lower ball joint to knuckle nut and bolt (1).
- Separate the lower control arm from the knuckle.
- Remove and DISCARD the front lower control arm nut and bolt (1).
- Remove and DISCARD the rear lower control arm bushing nuts and bolts (1).
- Remove the lower control (1) arm from the front frame.
Lower Control Arm Replacement
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools. ...
Installation Procedure
Position the lower control arm (1) in the cradle.
Install and hand tighten the NEW rear lower control arm bushing nuts and
bolts (1).
Install and hand tighten the NEW fro ...
Other materials:
How To Indentify Plastic Parts
Plastic parts can be identified by the SAE code, which is usually found on
the rear of the part, and/or by the characteristics of the plastic.
Knowing the type of plastic aids in selecting the proper repair materials and in
selecting the proper repair procedure.
Look for the SAE code s ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Dis ...
Heated Oxygen and Oxygen Sensor Caution
Caution: Do not remove the pigtail from either the heated oxygen
sensor (HO2S) or the oxygen sensor (O2S). Removing the pigtail or the
connector will affect sensor operation.
Handle the oxygen sensor carefully. Do not drop the HO2S. Keep the in-line
electrical connector and the louvered end fr ...
