Service Publications Ordering Information
Reporting Safety Defects to the United States GovernmentInstallation Procedure
Clean and prepare the attaching surfaces for brazing.
Apply structural adhesive to the attaching surfaces.
Position the rear bumper impact bar stud plate on the vehicle.
Verify the fit of the rear bumper impact bar stud plate
Clamp the rear bumper impact bar stud plate into ...
Reporting Safety Defects to the United States Government
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic
Safety Administration (NHTSA) in addition to notifying General Motors.
If NHTSA receives similar complaints, it may open an investig ...
Work Stall Test Warning
Warning: One or more of the following guidelines may apply when performing
specific required tests in the work stall:
When a test requires spinning the drive wheels with the vehicle jacked up,
adhere to the following precautions:
Do not exceed 56 km/h (35 mph) when spinning one drive wheel ...