Chevrolet Cruze Repair Manual: Seat Belt System Description and Operation

Seat Belt Latch Stop Installation

Preliminary Procedure Locate the hole in the seat belt webbing where the original seat belt stop button was located. If the original hole in the seat belt webbing is not visible, perform ...

Restraint System

Note: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision for additional information. Vehicle has front and rear seat belts that are the primary mean ...

Other materials:

Steering Angle Sensor Calibration Warning
Warning: For vehicles with electric power steering (EPS) and without a vehicle stability enhancement program, the steering angle sensor MUST always be calibrated after the battery has been disconnected. Failure to calibrate the steering angle sensor could limit the operation of the EPS system ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR   Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

Front Fog Lamp Replacement
Preliminary Procedures Raise and support the vehicle. Refer to Lifting   and Jacking the Vehicle. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Disconnect fog lamp bulb socket electrical connector. Front Fog Lamp Screws (Qty: 3) Caution: Refer t ...