Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Service

This vehicle may have the new environmentally friendly refrigerant, R1234yf. This refrigerant has a significantly reduced global warming impact on the environment, compared to the traditional automotive refrigerant, R-134a. All vehicles have a label underhood that identifies the refrigerant used in the vehicle.

The refrigerant system should only be serviced by trained and certified technicians. The air conditioning evaporator should never be repaired or replaced by one from a salvage vehicle. It should only be replaced by a new evaporator to ensure proper and safe operation.

During service, all refrigerants should be reclaimed with proper equipment. Venting refrigerants directly to the atmosphere is harmful to the environment and may also create unsafe conditions based on inhalation, combustion, frostbite, or other health-based concerns.

Passenger Compartment Air Filter
The filter removes dust, pollen, and other airborne irritants from outside air that is pulled into the vehicle. The filter should be replaced as part of routine scheduled maintenance. ...

Driving and Operating
...

Other materials:

Online Owner Center
Online Owner Experience (U.S.) my.chevrolet.com The Chevrolet online owner experience is a one-stop resource that allows interaction with Chevrolet and keeps important vehicle-specific information in one place. Membership Benefits (Vehicle Information): Download owner manuals and view vehicle ...

Hood Primary Latch Release Cable Replacement
Preliminary Procedure Remove hood primary latch release cable handle. Refer to Hood Primary Latch  Release Cable Handle Replacement. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement Remove the radiator grille support. Refer to Radiator Grille Reinforcem ...

Installation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so that the slit in the insulator is facing the rear of the vehicle. Install the insulator c 2. lamp to the insulator: 2.1. Position the clamp (2) over on the insulator. 2.2. Use two M8 bolts (1, 3) with 40 ...

© 2011-2026 Copyright www.ccruze.com