Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: SIR Inflator Module Handling and Storage Warning

Chevrolet Cruze Repair Manual / Preface / SIR Inflator Module Handling and Storage Warning

Warning: When carrying an undeployed inflator module:

When storing an undeployed inflator module:

Failure to observe these guidelines may result in personal injury.

SIR Seatbelt Pretensioner Handling Warning

Warning: When carrying an undeployed inflatable restraint seat belt retractor pretensioner:

Failure to observe these guidelines may result in personal injury.

SIR Special Tool Warning

Warning: Failure to observe the special tool recommendations and instructions could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

SIR Warning

Warning: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

In order to avoid the above conditions, observe the following guidelines:

Relieving Fuel Pressure Warning
Warning: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a ...

Steering Angle Sensor Calibration Warning
Warning: For vehicles with electric power steering (EPS) and without a vehicle stability enhancement program, the steering angle sensor MUST always be calibrated after the battery has been disconne ...

Other materials:

Roof
Sunroof The sunroof only operates when the ignition is in ON/RUN or ACC/ ACCESSORY, or when Retained Accessory Power (RAP) is active. To open or close the sunroof, press the open or close sunroof switch (1) to the first detent position. To express open or close the sunroof with the safety f ...

Installation Procedure
Clean and prepare the attaching surfaces for brazing. Apply structural adhesive to the attaching surfaces. Position the rear bumper impact  bar stud plate on the vehicle. Verify the fit of the rear bumper impact bar stud plate Clamp the rear bumper impact bar stud plate into ...

Installation Procedure
Apply structural adhesive on the flanges of the rear side door inner panel where the rear side door outer panel bears on. Align the rear side door outer panel. Verify the fit of the rear side door outer panel. Clamp the rear side door outer  panel into position. Pre-fla ...

© 2011-2026 Copyright www.ccruze.com