Chevrolet Cruze Repair Manual: Squeaks and Rattles

Interior Windnoise

Warning: Refer to Assistant Driving Warning in the Preface section. Interior windnoise is not heard when the window is lowered. Interior windnoise is caused by the air leaving the inside of the veh ...

Squeaks and Rattles

Note: Squeaks and rattles are caused by improperly controlled relative motion between vehicle components. There are 4 ways to prevent squeaks and rattles. Attach the component that squeaks or r ...

Other materials:

Problems with Route Guidance
Inappropriate route guidance can occur under one or more of the following conditions: •  The turn was not made on the road indicated. • Route guidance might not be available when using automatic rerouting for the next right or left turn. • The route might not be changed when using automati ...

Rear Compartment Lid Emblem/Nameplate Replacement (Chevrolet)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the tail lamp pocket as noted  from the original panel. Note: Clean and prepare the attaching surfaces for welding. Position the tail lamp pocket on the vehicle. Verify the fit of the tail lamp pocket. Clamp ...