Special Tools
CH-804 Drive Axle Seal Clamp Pliers
Removal Procedure
Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.
Note: After removing the boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the inner tie rod.
Installation Procedure
Note: The steering gear boot must seat in the appropriate groove on the steering gear.
Power Steering Fluid Reservoir Outlet Hose Replacement
Preliminary Procedure
Hose Clamp
Procedure
Compress the power steering fluid reservoir outlet hose clamp from the power steering pump and power steering fluid reservoir.
Power Steering Fluid Reservoir Outlet Hose
Procedure
Fill and bleed the power steering system. Refer to Power Steering System Bleeding.
Tip
Clean any excess power steering fluid from the vehicle.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Dis ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to ...
Vehicle, Engine and Transmission ID and VIN Location, Derivative and Usage
Note:: Graphic shows exemplary VIN.
The VIN plate is the legal identifier of the vehicle. The VIN plate is
located on the upper left corner of the instrument panel (I/P) and can
be seen through the windshield from the outside of the vehicle:
...