Chevrolet Cruze Repair Manual: Steering Linkage Inner Tie Rod Replacement (Electronic Power Steering)
Special Tools
CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod
For equivalent regional tools, refer to Special Tools.
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.
- Remove the steering gear boot. Refer to Steering Gear Boot Replacement.
- Remove the steering linkage inner tie rod with CH-6247 remover/installer .
Installation Procedure
- Apply threadlock compound to the threads of the inner tie rod.
Caution: Refer to Fastener Caution in the Preface section.
- Install the steering linkage inner rod using the CH-6247 remover/installer and tighten to 105 N·m (77 lb ft).
- Install the steering gear boot. Refer to Steering Gear Boot Replacement.
- Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Measure the wheel alignment. Refer to Wheel Alignment Measurement.
- Adjust front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment.
- Center the steering angle sensor. Refer to Steering Angle Sensor Centering.
Steering Linkage Inner Tie Rod Replacement (Hydraulic Power Steering)
Special Tools
CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle ...
Power Steering System Description and Operation
The hydraulic power steering pump is a constant displacement vane-type pump
that provides hydraulic pressure and flow for the power
steering gear. The hydraulic power steering pumps are either belt ...
Other materials:
Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
Create a 50 mm (2 in) backing plate from the unused portion
&nbs ...
Instrument Panel Lower Trim Pad Cover Replacement
Preliminary Procedure
Remove the left outer trim cover. Refer to Instrument Panel Outer Trim Cover
Replacement - Left Side.
Instrument Panel Lower Trim Pad Cover Screw (Qty: 3)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2.5 N·m (23 lb in)
Instrument Panel ...
Using the System
The infotainment system is controlled by touching the screen, and by using the
knobs and other buttons.
Voice recognition, through the steering wheel controls, can be used to control
the infotainment features.
Press on the steering wheel controls
to begin voice recognition.
See Voice Recog ...
