Chevrolet Cruze Repair Manual: Tail Lamp Replacement
Preliminary Procedures
- Open and support the rear compartment lid.
- Remove the body side trim panel replacement in order to expose the tail lamp pocket nuts. Refer to Body Side Trim Panel Replacement - Left Side.
- Tail Lamp Bolt (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (22 lb ft)
- Tail Lamp Control Module with Bulb Assembly
Tip
Rotate the control module with bulbs counterclockwise and remove from the tail lamp housing.
- Tail Lamp Assembly
Warning: Refer to Halogen Bulb Warning in the Preface section.
Procedure
- Using a blunt tool, tap gently on the tail lamp studs before attempting to remove the tail lamp assembly from the lamp pocket.
- Pull the tail lamp assembly rearward.
- Disconnect the tail lamp control module with bulbs assembly electrical connector.
Tail Lamp Bulb Replacement
Preliminary Procedure
Remove the rear tail lamp assembly. Refer to Tail Lamp Replacement.
- Tail Lamp Bulb Harness Socket
Procedure
Rotate the bulb socket from the tail lamp housing.
- Tail Lamp Bulb
Procedure
Pull the bulb straight from the lamp harness socket
Forward Lamp Wiring Harness Replacement
Preliminary Procedures
Remove the front bumper. Refer to Front Bumper Fascia Replacement.
Remove the headlamp. Refer to Headlamp Replacement.
Using a scan tool, check for DTCs.
Forward ...
Exterior Lighting Systems Description and Operation
Exterior Lamps
The exterior lighting system consists of the following lamps if equipped:
Headlamps
Daytime Running Lamps (DRL)
Front fog lamps
Rear fog lamps
Park, tail and license lamps
...
Other materials:
Installation Procedure
Position the front end upper tie bar (1) on the vehicle.
Verify the fit of the front end upper tie bar.
Clamp the front end upper tie bar into position.
Weld seam accordingly.
Weld seam accordingly.
Grind down weld seams as needed for related panels and components.
...
Front Bumper Fascia Replacement
Preliminary Procedure
Remove the front bumper fascia opening cover. Refer to Front Bumper Fascia
Opening Lower Cover Replacement.
Front Wheelhouse Liner Bolt (Qty: 8)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2.5 N·m(23 lb in)
Front Bumper Fascia Bolt (Q ...
Hazard Warning Flashers
(Hazard Warning Flasher):
Press and momentarily hold this button on the instrument panel above the climate
control system, to make the front and rear turn signal lamps flash on and off. This
warns others that you are having trouble.
Press and momentarily hold again to turn the flashers off ...
