Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Tire Pressure Light

For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on

For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS.

When the Light Is On Steady

This indicates that one or more of the tires are significantly underinflated.

A Driver Information Center (DIC) tire pressure message may also display.

When the Light Flashes First and Then Is On Steady

If the light flashes for about a minute and then stays on, there may be a problem with the TPMS. If the problem is not corrected, the light will come on at every ignition cycle.

Traction Control System (TCS)/StabiliTrak® Light
The StabiliTrak or Traction Control System (TCS) indicator/warning light comes on briefly when the engine is started. If the light does not come on, have the vehicle serviced by your dealer. If ...

Engine Oil Pressure Light
Notice: Lack of proper engine oil maintenance can damage the engine. Driving with the engine oil low can also damage the engine. The repairs would not be covered by the vehicle warranty. Check th ...

Other materials:

Hood Adjustment
Hood Caution: Refer to Fastener Caution in the Preface section. Procedure Loosen the hood hinge reinforcement nuts (Qty: 4). Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the front bumper fascia and so that the hood ...

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of the rear floor panel filler as noted  from the original panel. Clean and prepare the atta ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the rear bumper impact bar stud plate as noted from the original panel. Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Clean and prepare the ...

© 2011-2026 Copyright www.ccruze.com