Removal Procedure
Warning: If penetrating oil gets on the vertical surfaces between the wheel and the rotor or drum it could cause the wheel to work loose as the vehicle is driven, resulting in loss of control and an injury accident.
Caution: Removing the wheel may be difficult because of foreign materials or a tight fit between the wheel and the hub/rotor.
Slightly tap the tire side wall with a rubber mallet in order to remove the wheel. Failure to follow these instructions may result in damage to the wheel.
5.1. Install and tighten all wheel nuts on the affected wheel.
5.2. Loosen each wheel nut two turns.
5.3. Lower the vehicle.
5.4. Rock the vehicle from side to side.
5.5. Repeat this procedure if necessary.
6.1. Start the engine.
6.2. Drive the vehicle forward and rearward slightly while applying quick, hard jabs of the brakes prior to changing direction.
6.3. Repeat this procedure if necessary.
Installation Procedure
Warning: Before installing the wheels, remove any buildup of corrosion on the wheel mounting surface and brake drum or disc mounting surface by scraping and wire brushing. Installing wheels with poor metal-to-metal contact at the mounting surfaces can cause wheel nuts to loosen. This can cause a wheel to come off when the vehicle is moving, causing loss of control and possibly personal injury.
Note: Wheel nuts, studs, and mounting surfaces must be clean and dry.
Caution: Refer to Fastener Caution in the Preface section.
Note: Tighten the nuts evenly and alternately in the sequence shown, in order to avoid excessive runout.
Fog Lamp Aiming
Preparation Procedure
Important: Horizontal aim is not adjustable on this vehicle.
Vertical aim is done by an adjusting nut located on the rear of the fog lamp.
Prior to aiming the fog lamps, perform the following steps:
Completely assemble all of the components on the vehicle.
Place the ...
Drive Belt Replacement
Special Tools
EN 6349 Locking Pin
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Open the hood.
Remove the power steering pump belt. Refer to Power Steering Pump Belt
Replacement.
Raise the vehicle by its full height. Refer to Lifting and Jacking the
Vehicl ...
Headlamp High/Low-Beam Changer
(Headlamp High/Low-Beam Changer):
Push the turn signal lever away from you and release to turn the high beams on.
To return to low beams, push the lever again or pull it toward you and release.
This indicator light turns on in the instrument cluster when the high-beam headlamps
are on. ...