Chevrolet Cruze Repair Manual: Ultra High Strength Dual Phase Steel

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Ultra High Strength Dual Phase Steel

This information provides repair recommendations and general guidelines for steel classified as Ultra High Strength Dual Phase Steel (Dual Phase Steel with a tensile strength greater than 800 MPa), also known as DPX.

General Motors recommends the following when repairing or replacing this type of steel during collision repair.

Note:

Repair of this type of steel is not recommended.
This type of steel should be replaced at factory joints only. Sectioning or partial replacement is not recommended.
The use of heat to repair damage is not recommended for this type of steel.
Stitch Welding is not recommended for this type of steel.
This classification of steel can not be used as a backing reinforcement or a sleeve for a sectioning joint, unless a specific procedure is available.

Recommended Repairs:

Squeeze Resistance Spot Welding can be used to replace factory spot welds, where applicable.
MIG plug welding can be used to replace factory spot welds.
MIG Brazing can be used to replace factory spot welds.

Special Tools and Equipment

Frame and Underbody

Mild Steel

This information provides repair recommendations and general guidelines for steel classified as Mild Steel. This type of steel normally has a tensile strength less than 270 MPa. This includes the c ...

Frame and Underbody

Specifications Engine Shield Replacement Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Engine Shield Bolt (Qty: 4) Caution: Refer to ...

Other materials:

Lower Anchors and Tethers for Children (LATCH System)
The LATCH system secures a child restraint during driving or in a crash. LATCH attachments on the child restraint are used to attach the child restraint to the anchors in the vehicle. This system is designed to make installation of a child restraint easier. Make sure that a LATCH-compatible ch ...

Installation Procedure
Remove all mounds or loose pieces of urethane adhesive from the pinch-weld area. Inspect for any of the following problems in order to help prevent future breakage of the window: High weld Solder spots Hardened sealer Any other obstruction or irregularity in the pinch-weld fla ...

Mirrors
Specifications Inside Rearview Mirror Schematics Outside Rearview Mirror Schematics Outside Rearview Mirror Replacement Preliminary Procedure Remove the front side door trim. Refer to Front Side Door Trim Replacement. Remove the front side door upper trim cove ...