At times, the position of the vehicle on the map could be inaccurate due to one or more of the following reasons: • The road system has changed.
• The vehicle is driving on slippery road surfaces such as sand, gravel, or snow.
• The vehicle is traveling on winding roads or long straight roads.
• The vehicle is approaching a tall building or a large vehicle.
• The surface streets run parallel to a freeway.
• The vehicle has been transferred by a vehicle carrier or a ferry.
• The current position calibration is set incorrectly.
• The vehicle is traveling at high speed.
• The vehicle changes directions more than once, or the vehicle is turning on a turn table in a parking lot.
• The vehicle is entering and/or exiting a parking lot, garage, or a lot with a roof.
• The GPS signal is not received.
• A roof carrier is installed on the vehicle.
• Tire chains have been installed.
• The tires are replaced or worn.
• The tire pressure for the tires is incorrect.
• This is the first navigation use after the map data is updated.
• The 12-volt battery is disconnected for several days.
• The vehicle is driving in heavy traffic where driving is at low speeds, and the vehicle is stopped and started repeatedly.
Tire Rotation
Tires should be rotated every 12 000 km (7,500 mi).
Tires are rotated to achieve a uniform wear for all tires. The first rotation
is the most important.
Anytime unusual wear is noticed, rotate the tires as soon as possible, check
for proper tire inflation pressure, and check for damaged tires ...
Installation Procedure
Cut the front compartment upper side rail in corresponding locations to
fit the remaining original panel. The sectioning joint should
be trimmed to allow a gap of one-and-one-half-times the metal thickness at
the sectioning joint.
Create a 50 mm (2 in) backing plate from the unused ...
Strut Assembly Replacement
Special Tools
CH 49375 Wrench
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
Installation.
Separate the brake hose ...