Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Windshield Washer Pump Seal Replacement

Chevrolet Cruze Repair Manual / Body systems / Wipers and Washers / Windshield Washer Pump Seal Replacement

Removal Procedure

  1. Open the hood.
  2. Remove the windshield washer pump. Refer to Windshield Washer Pump Replacement
  3. Using a small flat-bladed tool, remove the washer pump terminal seal (1) from the washer solvent container (2).

Installation Procedure

  1. Position the washer pump terminal seal (1) to the washer solvent container (2), pressing in until fully seated.
  2. Install the windshield washer pump. Refer to Windshield Washer Pump Replacement
  3. Close the hood.

Air Inlet Grille Panel Replacement

Preliminary Procedure

Preliminary Procedure

Remove the wiper arms. Refer to Windshield Wiper Arm Replacement.

  1. Air Inlet Grille Panel Clip (Qty: 5)
  2. Air Inlet Grille Panel Assembly

Procedure

Remove hood rear weatherstrip.

Windshield Washer Pump Replacement
Removal Procedure Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. Disconnect the washer pump electrical connector (1). Disconnect the washer pump hose (2 ...

Windshield Wiper Arm Replacement
Windshield Washer Arm Finish Cap Tip Use a small flat-bladed tool to remove finish cap. Special Tools BO-6626 Wiper Arm Puller For equivalent regional tools, refer to Special Tools. ...

Other materials:

Infotainment
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET, the CHEVROLET Emblem, CRUZE, and the CRUZE logo are trademarks and/or service marks of General Motors LLC, its subsidiaries, a ...

Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Left Side)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

Uniform Tire Quality Grading
Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 Traction AA Temperature A The following information relates to the system developed by the United States National Highway Traffic Safety Administration ...

© 2011-2024 Copyright www.ccruze.com