Chevrolet Cruze Owners Manual: Lamp Messages
AUTOMATIC LIGHT CONTROL ON
This message is displayed when the automatic light control has been turned on.
AUTOMATIC LIGHT CONTROL OFF
This message is displayed when the automatic light control has been turned off.
XXX TURN INDICATOR FAILURE
When one of the turn signals is out, this message displays to show which bulb needs to be replaced.
TURN SIGNAL ON
This message is displayed if the turn signal has been left on. Turn off the turn signal.
Key and Lock Messages
NO REMOTE DETECTED
This message displays when the transmitter battery is weak on vehicles with keyless
access.
REPLACE BATTERY IN REMOTE KEY
This message displays when the battery in the Remote K ...
Object Detection System Messages
PARK ASSIST OFF
This message displays when the park assist system has been turned off or when
there is a temporary condition causing the system to be disabled.
SERVICE PARK ASSIST
This message di ...
Other materials:
Introduction
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs
appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET,
the CHEVROLET Emblem, and CRUZE are trademarks and/or service marks of General Motors
LLC, its subsidiaries, affiliates, or li ...
Front Bumper Energy Absorber Bracket Replacement
Preliminary Procedure
Remove the front bumper fascia opening cover. Refer to Front Bumper Fascia
Opening Lower Cover Replacement
Drivetrain and Front Suspension Frame Bolt Front
Caution: Refer to Fastener Caution in the Preface section.
Tighten
160 N·m (119 lb ft)
Note: Do NOT reu ...
Installation Procedure
Install NEW stabilizer shaft insulators (1) to stabilizer shaft (2) so
that the slit in the insulator is facing the rear of the vehicle.
Install the insulator c 2. lamp to the insulator:
2.1. Position the clamp (2) over on the insulator.
2.2. Use two M8 bolts (1, 3) with 40 ...
