Chevrolet Cruze Owners Manual: Instruments and Controls
- Controls
- Steering Wheel Adjustment
- Steering Wheel Controls
- Horn
- Windshield Wiper/Washer
- Compass
- Clock
- Power Outlets
- Cigarette Lighter
- Ashtrays
- Warning Lights, Gauges, and Indicator
- Instrument Cluster
- Speedometer
- Odometer
- Trip Odometer
- Tachometer
- Fuel Gauge
- Engine Coolant Temperature Gauge
- Safety Belt Reminders
- Airbag Readiness Light
- Passenger Airbag Status Indicator
- Charging System Light
- Malfunction Indicator Lamp
- Brake System Warning Light
- Antilock Brake System (ABS) Warning Light
- Up-Shift Light
- Power Steering Warning Light
- Traction Off Light
- StabiliTrak® OFF Light
- Traction Control System (TCS)/StabiliTrak® Light
- Tire Pressure Light
- Engine Oil Pressure Light
- Low Fuel Warning Light
- Security Light
- Reduced Engine Power Light
- High-Beam On Light
- Front Fog Lamp Light
- Lamps On Reminder
- Cruise Control Light
- Door Ajar Light
- Information Displays
- Vehicle Messages
- Battery Voltage and Charging Messages
- Brake System Messages
- Compass Messages
- Cruise Control Messages
- Door Ajar Messages
- Engine Cooling System Messages
- Engine Oil Messages
- Engine Power Messages
- Fuel System Messages
- Key and Lock Messages
- Lamp Messages
- Object Detection System Messages
- Ride Control System Messages
- Airbag System Messages
- Security Messages
- Service Vehicle Messages
- Starting the Vehicle Messages
- Tire Messages
- Transmission Messages
- Vehicle Reminder Messages
- Vehicle Personalization
Additional Storage Features
Cargo Tie-Downs
On the driver side in the rear compartment is a retainer to hang light items
on. ...
Controls
...
Other materials:
Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
Create 50 mm (2 in) backing plates from the unused portion of the
...
Removal Procedure
Warning: Refer to Cracked Window Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Note: Position the vehicle on level ground and move the front
wheels to the straight-ahead position.
Disconnect battery.
Remove quarter window ...
