Chevrolet Cruze Owners Manual: Cruise Control Messages
APPLY BRAKE BEFORE CRUISE
If this message displays when attempting to activate cruise control, apply the brake pedal and try again.
CRUISE SET TO XXX
This message displays when the cruise control is set and shows the speed it was set to.
Compass Messages
CAL
This message is displayed when the compass needs to be calibrated.
– –
Two dashes will be displayed if the compass needs service. See your dealer for
service. ...
Door Ajar Messages
DOOR(S) OPEN
A vehicle symbol will be displayed on the DIC showing which door is open along
with this message.
Close the door completely.
HOOD OPEN
This message will display when the hood is ope ...
Other materials:
Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioning
joint.
Create 50 mm (2 in) backing plates from the unused portion of the
...
Front Side Door Wiring Harness Replacement
Preliminary Procedure
Remove the front side door inner panel trim. Refer to Front Side Door Trim
Replacement.
Front Side Door Wiring Harness
Warning: Unless directed otherwise, the ignition and start switch must be
in the OFF or LOCK position, and all electrical
loads must be OFF before ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges
of the tail lamp pocket as noted f rom the
original panel.
Note:
Clean and prepare the attaching surfaces for brazing.
Position the tail lamp pocket on the vehicle.
Verify the fit of the ta ...
