Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Transmission Messages

SERVICE TRANSMISSION

This message displays if there is a problem with the transmission. See your dealer.

TRANSMISSION HOT — IDLE ENGINE

This message displays and a chime sounds if the transmission fluid in the vehicle gets hot. Driving with the transmission fluid temperature high can cause damage to the vehicle.

Stop the vehicle and let it idle to allow the transmission to cool. This message clears when the fluid temperature reaches a safe level.

Tire Messages
SERVICE TIRE MONITOR SYSTEM This message displays if there is a problem with the Tire Pressure Monitor System (TPMS). TIRE LEARNING ACTIVE This message displays when the system is learning new ti ...

Vehicle Reminder Messages
ICE POSSIBLE DRIVE WITH CARE This message displays when ice conditions are possible. STEERING COLUMN IS LOCKED This message displays when the steering column is locked. ...

Other materials:

Power Steering Gear Inlet Pipe/Hose Replacement
Removal Procedure Remove front bumper fascia. Refer to Front Bumper Fascia Replacement Remove as much power steering fluid from the remote power steering fluid reservoir as possible. Place drain pans under the vehicle as needed. Remove power steering gear inlet hose bolt (1). ...

Installation Procedure
Clean and prepare the attaching surfaces for brazing. Apply structural adhesive to the attaching surfaces. Position the rear bumper impact  bar stud plate on the vehicle. Verify the fit of the rear bumper impact bar stud plate Clamp the rear bumper impact bar stud plate into ...

Rear Compartment Lid Emblem/Nameplate Replacement (Chevrolet)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2011-2026 Copyright www.ccruze.com