: Press to turn the system on and
off. Turn to increase or decrease the volume.
BAND: Press to choose between FM, AM, or SiriusXM®, if equipped.
MENU/SEL: Turn to select radio stations. Press to select a menu.
: Press to seek the previous station
or track.
: Press to seek the next station
or track.
Buttons 1 to 6: Press to save and select favorite stations.
INFO: Press to show available information about the current station or track.
Storing a Favorite Station
Stations from all bands can be stored in the favorite lists in any order. Up to six stations can be stored in each favorite page and the number of available favorite pages can be set.
To store the station to a position in the list, press the corresponding numeric button 1 to 6 until a beep is heard.
Setting the Clock
Adjusting the Time or Date
To set the time and date for the radio with navigation:
1. Press CLOCK.
2. Select Set Time or Set Date.
3. Turn the MENU/SEL knob to adjust the highlighted number.
4. Press the MENU/SEL knob to select the next number.
5. To save the settings, press the BACK on the radio faceplate.
Setting the 12/24 Hour Format
To set the 12/24 hour format for the radio with navigation: 1. Press CLOCK.
2. Highlight 12/24 Hour Format.
3. Press the MENU/SEL knob to select the 12 hour or 24 hour display format.
4. To save the settings, press the BACK on the radio faceplate.
Vehicle Features
Satellite RadioRepairs and Inspections Required After a Collision
Warning: Restraint systems can be damaged in a collision. To help
avoid injury and ensure that all parts in need of replacement are
replaced:
Replace any seat belt system that was in use during the
collision serious enough to deploy any automatic restraint device such as
air
bags and ...
Engine Overheating
There is an engine coolant temperature gauge on the vehicle instrument cluster
to warn of engine overheating.
If the decision is made not to lift the hood when this warning appears, get service
help right away.
If the decision is made to lift the hood, make sure the vehicle is parked on
a le ...
Tracing Powder or Chalk Test
Clean the weatherstrips and the contact surfaces with cleaning solvent.
Apply powder or chalk in an unbroken line to the contact surface of the
weatherstrip surrounding the perimeter of the suspected
areas.
Close the panel completely without slamming the panel. Closing the panel
comple ...