Chevrolet Cruze Repair Manual: Hood Primary Latch Release Cable Replacement
Preliminary Procedure
- Remove hood primary latch release cable handle. Refer to Hood Primary Latch Release Cable Handle Replacement.
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement
- Remove the radiator grille support. Refer to Radiator Grille Reinforcement Support Replacement.
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement.
Hood Primary Latch Release Cable
Procedure
To release the hood primary latch release cable, unhook from hood primary and secondary latch.
Front Fender Front Lower Bracket Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement.
Remove the headlamp. Refer to Headlamp Replacement
Remove the front fender. R ...
Rear Side Door Check Replacement
Preliminary Procedure
Remove rear side door trim panel. Refer to Rear Side Door
Trim Replacement
Remove the rear side door water deflector. Refer to Rear Side Door Water
De ...
Other materials:
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the brake rotor. Refer to Front Brake Rotor Replacement.
Remove the wheel speed sensor screw (2).
Remove the wheel speed sensor (1) from the steering knuckle.
Remove the wheel drive shaft from the fron ...
Deployment Outside Vehicle - Steering Wheel Module, Instrument Panel
Module, and Roof Rail Module
Deploy the inflator module outside of the vehicle when the vehicle will be
returned to service. Situations that require deployment outside
of the vehicle include the following:
Using the SIR diagnostics, you determine that the inflator module is
malfunctioning
The inflator module is cosm ...
Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-Brazing along the edges
of the front wheelhouse front panel as noted from the
original panel.
Create a 5 x 18 mm (4/16 x 11/16 in) slot for MIG-Brazing where front
wheelhouse front panel and front wheelhouse overlap.
C ...
