Chevrolet Cruze Repair Manual: Bolted Exterior Body Panels and Closures
Specifications
- Front End Upper Tie Bar Replacement
- Front Fender Front Lower Bracket Replacement
- Hood Primary Latch Release Cable Replacement
- Rear Side Door Check Replacement
- Front Side Door Adjustment
- Front Side Door Replacement
- Rear Side Door Adjustment
- Rear Side Door Replacement
- Front Fender Replacement
- Front Side Door Wiring Harness Replacement
- Rear Side Door Wiring Harness Replacement
- Hood Primary Latch Release Cable Handle Replacement
- Front Side Door Upper Hinge and Lower Hinge Replacement
- Rear Side Door Upper Hinge and Lower Hinge Replacement
- Hood Adjustment
- Hood Replacement
- Hood Primary and Secondary Latch Replacement
- Rear Compartment Lid Adjustment
- Rear Compartment Lid Replacement
- Front Side Door Check Replacement
- Fuel Tank Filler Pipe Housing Replacement
- Hood Hold-Open Rod Replacement
- Rear Compartment Lid Hinge Torque Rod Replacement
- Radiator Grille Reinforcement Support Replacement
- Front Side Door Weatherstrip Replacement - Door Side
- Front Side Door Weatherstrip Replacement - Body Side
- Rear Compartment Lid Weatherstrip Replacement
- Rear Side Door Weatherstrip Replacement - Door Side
- Rear Side Door Weatherstrip Replacement - Body Side
Body repair
...
Front End Upper Tie Bar Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement
Remove the radiator support bracket. Refer to Radiator Support Bracket
Replacement
...
Other materials:
Front Seat Cushion Cover and Pad Replacement
Removal Procedure
Warning: Refer to SIR Warning in the Preface section.
Warning: Replace the passenger presence system as a complete assembly to prevent
possible injury to the occupant. The bladder, the
pressure sensor, the seat cushion, and the control module are assembled and
calibrated a ...
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the tire and wheel. Refer to Tire and Wheel Removal and
Installation.
Note: DO NOT re-use the lower control arm bolts and nuts. Discard
and use NEW only.
Remove wheel speed sensor wiring harness ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to ...
