Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Driver or Passenger Seat Retractor Side Belt Replacement

Chevrolet Cruze Repair Manual / Restraints / Driver or Passenger Seat Retractor Side Belt Replacement

Warning: Refer to SIR Warning in the Preface section.

Warning: Refer to SIR Warning in the Preface section.

Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.

Warning: Refer to SIR Seatbelt Pretensioner Handling Warning in the Preface section.

Preliminary Procedure

  1. Remove the Center Pillar Upper Garnish Molding. Refer to Center Pillar Upper Garnish Molding Replacement.
  2. Remove the Front Seat Outer Recliner Upper Finish Cover. Refer to Front Seat Outer Recliner Upper Finish Cover Replacement.
  1. Front Seat Belt Anchor Plate Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten 9 N·m (80 lb in)

  1. Front Seat Belt Retractor D Ring Bolt

Tighten 45 N·m (33 lb ft)

  1. Front Seat Shoulder Belt Guide Retainer
  2. Front Seat Shoulder Belt Retractor Assembly Bolt

Tighten 45 N·m (33 lb ft)

  1. Front Seat Retractor Side Belt Assembly
Roof Side Rail Inflatable Restraint Module Replacement
Warning: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF ...

Repairs and Inspections Required After a Collision
...

Other materials:

Intermediate Steering Shaft Replacement
Removal Procedure Turn the steering wheel to the straight forward position and support it from movement Remove the 2 intermediate steering shaft bolts (1). Remove the intermediate steering shaft (1). Installation Procedure Install the intermediate steering shaft ...

Engine Compartment Fuse Block
To remove the fuse block cover, squeeze the clips and swing it up. Notice: Spilling liquid on any electrical component on the vehicle may damage it. Always keep the covers on any electrical component. Engine Compartment Fuse Block The vehicle may not be equipped with all of the fuses, relay ...

Front Lower Control Arm Bushing Replacement
Preliminary Procedure Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation. Remove the lower control arm. Refer to Lower Control Arm Replacement. Lower Control Arm Rear Bushing ...

© 2011-2026 Copyright www.ccruze.com