Chevrolet Cruze Repair Manual: Steering Angle Sensor Calibration Warning
Warning: For vehicles with electric power steering (EPS) and without a vehicle stability enhancement program, the steering angle sensor MUST always be calibrated after the battery has been disconnected. Failure to calibrate the steering angle sensor could limit the operation of the EPS system and result in personal injury.
To ensure proper calibration of the EPS system, do the following:
- The engine should be o 1. n with the vehicle stationary.
- Turn the steering wheel counterclockwise until it stops.
- Turn the steering wheel clockwise until it stops.
Window Retention Warning
Warning: When replacing stationary windows, only use a single component adhesive kit, or an adhesive system meeting GM Specifications, to maintain original installation integrity. Failure to use the single component adhesive kit will result in poor retention of the window which may allow unrestrained occupants to be ejected from the vehicle resulting in personal injury.
SIR Inflator Module Handling and Storage Warning
Warning: When carrying an undeployed inflator module:
Do not carry the inflator module by the wires or connector.
Make sure the air bag opening points away from you.
When storing an undeploye ...
Work Stall Test Warning
Warning: One or more of the following guidelines may apply when performing
specific required tests in the work stall:
When a test requires spinning the drive wheels with the vehicle jacked up,
ad ...
Other materials:
Using the Navigation System
Use the NAV button on the faceplate or Home Page to access the navigation map.
Press the NAV button again to change between alternative views of the normal
split and full map views.
The Menu screen button at the bottom right side of the display accesses the Navigation
Menu.
The touch-sens ...
Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining
original panel. The sectioning joint should be trimmed to allow a
gap of one-and-one-half-times the metal thickness at the sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of the
serv ...
Exhaust Flexible Pipe Replacement (1.6L LXT)
Removal Procedure
Warning: Refer to Hot Exhaust System Warning in the Preface section.
Warning: Refer to Protective Goggles and Glove Warning in the Preface section.
Open the hood.
Raise the vehicle by its full height. Refer to Lifting and Jacking the
Vehicle.
Remove the heate ...
