Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Bumpers and Fascias

Specifications

Front Bumper Energy Absorber Replacement

Front Bumper Energy Absorber Replacement

Preliminary Procedure

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.

  1. Front Bumper Energy Absorber

Procedure

Unclip from front bumper fascia.

Rear Side Door Weatherstrip Replacement - Body Side
Rear Side Door Weatherstrip - Body Side Procedure Start at the front upper corner of the door opening and pull the weatherstrip away from   the door opening flange. Position th ...

Front Bumper Energy Absorber Bracket Replacement
Preliminary Procedure Remove the front bumper fascia opening cover. Refer to Front Bumper Fascia Opening Lower Cover Replacement Drivetrain and Front Suspension Frame Bolt Front Caution: ...

Other materials:

Steering Gear Boot Replacement
Special Tools CH-804 Drive Axle Seal Clamp Pliers Removal Procedure Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement. Remove the steering linkage inner tie rod nut (1). Remove the steering gear outer boot clamp (2). Loosen the st ...

California Fuel Requirements
If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications. See the underhood emission control label. If this fuel is not available in states adopting California Emissions Standards, the vehicle will operate satisf ...

Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Ensure that the steering wheel is set in a straight ahead position. Loosen the tie rod jam nut (1). Adjust the toe to specification by turning the adjuster (2). Refer to Wheel Alignment Specifications. Caution: Refer to Fastener Caution in the Preface section. Tighten the tie ro ...

© 2011-2026 Copyright www.ccruze.com