Chevrolet Cruze Repair Manual: Power Steering Pump Belt Replacement
Special Tools
CH 49800 Installer Power Steering Pump Belt
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Caution: Do not use belt dressing on the drive belt. Belt dressing causes the breakdown of the composition of the drive belt. Failure to follow this recommendation will damage the drive belt.
- Open the hood
- Cut the power steering pump belt (2) with a appropriate cutting tool at position (1).
- Remove the power steering pump belt (2)
Installation Procedure
- Relieve the tension of the drive belt (1). Refer to Drive Belt Replacement.
- Install CH-49800 installer (3) on the power steering pump pulley.
- Install NEW power steering belt (2) aligning pulley water pump.
- Rotate the power steering pump pulley clockwise using hex wrench on the shaft power steering pump pulley.
- Remove the CH-49800 installer (3).
- Check the belt is installed clearly.
- Install the drive belt. Refer to Drive Belt Installation
- Close the hood.
Exhaust Flexible Pipe Replacement (1.6L LXT)
Removal Procedure
Warning: Refer to Hot Exhaust System Warning in the Preface section.
Warning: Refer to Protective Goggles and Glove Warning in the Preface section.
Open the hood.
Raise the ...
Front Brake Rotor Replacement
Special Tools
CH-41013 Rotor Resurfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Brake Dust Warni ...
Other materials:
Installation Procedure
Position the front end upper tie bar (1) on the vehicle.
Verify the fit of the front end upper tie bar.
Clamp the front end upper tie bar into position.
Weld seam accordingly.
Weld seam accordingly.
Grind down weld seams as needed for related panels and components.
...
SIR Inflator Module Handling and Storage Warning
Warning: When carrying an undeployed inflator module:
Do not carry the inflator module by the wires or connector.
Make sure the air bag opening points away from you.
When storing an undeployed inflator module:
Make sure the air bag opening points away from the surface on which
the in ...
Installation Procedure
Align the rear compartment floor panel.
Drill 8 mm (5/16 in) for plug welding along the edges of the rear compartment
floor panel as noted from the original panel.
Clean and prepare the attaching surfaces for
welding.
Position the rear compartment floor panel on the vehicle.
V ...
