Chevrolet Cruze Repair Manual: Preface
- Definition of Danger, Warning, Caution, and Note
- Battery Disconnect Warning
- Fuel and Evaporative Emission Pipe Warning
- Halogen Bulb Warning
- Relieving Fuel Pressure Warning
- SIR Inflator Module Handling and Storage Warning
- Steering Angle Sensor Calibration Warning
- Work Stall Test Warning
- Heated Oxygen and Oxygen Sensor Caution
- Steering Column in Lock Position Caution
- Test Probe Caution
Definition of Danger, Warning, Caution, and Note
The diagnosis and repair procedures in a GM Service Manual contain both
general and specific Dangers, Warnings, Cautions, Notes or
Importants. GM is dedicated to the presentation of service informa ...
Other materials:
Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Left Side)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Restraint System
Note: If the vehicle has been in a collision, refer to Repairs and
Inspections Required After a Collision for additional information.
Vehicle has front and rear seat belts that are the primary means of occupant
restraint. Seat belts help to keep the occupants inside the
passenger compartment a ...
Front Wheel Drive Shaft Replacement - Right Side
Special Tools
CH-313 Slide Hammer
CH-6003 Axle Shaft Remover
CH-49376 Holding Wrench
CH-49400 Hub Spindle Remover
DT-6332 Seal Protector
EN-956-1 Extension
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: To prevent personal injury and/or component ...
