Chevrolet Cruze Repair Manual: Quarter Outer Panel Sectioning (MIG-Brazing)
Special Tools
- BO-6396 Bonding Pliers
- BO-6392 Flanging Tool Kit
For equivalent regional tools, refer to Special Tools.
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.
Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickn ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
Warning: Refer to Glass and She ...
Other materials:
Hood Replacement
Warning: When a hood hold open device is being removed or installed,
provide alternate support to avoid the possibility of
damage to the vehicle or personal injury.
Preliminary Procedure
Remove the windshield washer nozzle hose. Refer to Windshield Washer Nozzle
Hose Replacement.
Hood ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Bat ...
Roof Side Rail Inflatable Restraint Module Replacement
Warning: In order to prevent SIR deployment, personal injury, or
unnecessary SIR system repairs, do not strike the door or the
door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition
and remove the key when performing service in the
area of the SIS.
Warning: When pe ...
