Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Windshield Garnish Molding Replacement

Preliminary Procedure

Preliminary Procedure

Disable the SIR system. Refer to SIR Disabling and Enabling.

  1. Windshield Garnish Molding Assembly

Procedure

  1. Loosen  tether clip and steel clips.
  2. Disconnect electrical connector.
  3. The tether clip at the upper portion of the garnish molding MUST be replaced any time the garinish molding is removed.
Front Side Door Trim Replacement
Front Side Door Pull Handle Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in) Front Side Door Inside Handle Bolt Finish Cap Tip Pull handle ...

Center Pillar Upper Garnish Molding Replacement
Preliminary Procedure Remove the center pillar lower garnish molding. Refer to Center Pillar Lower Ga   rnish Molding Replacement Remove the seat belt from the front seat. Refer ...

Other materials:

Instrument Panel Lower Trim Pad Cover Replacement
Preliminary Procedure Remove the left outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement - Left Side. Instrument Panel Lower Trim Pad Cover Screw (Qty: 3) Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (23 lb in) Instrument Panel ...

Front Fender Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front  Bumper Fascia Replacement Remove front bumper fascia guide. Refer to Front Bumper Fascia Replacement Remove the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement Remove the headlamp. Refer to H ...

Reporting Safety Defects to the United States Government
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying General Motors. If NHTSA receives similar complaints, it may open an investig ...

© 2011-2026 Copyright www.ccruze.com