Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: California Fuel Requirements

Chevrolet Cruze Owners Manual / Driving and Operating / Fuel / California Fuel Requirements

If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications. See the underhood emission control label. If this fuel is not available in states adopting California Emissions Standards, the vehicle will operate satisfactorily on fuels meeting federal specifications, but emission control system performance might be affected. The malfunction indicator lamp could turn on and the vehicle might fail a smog‐check test.

If this occurs, return to your authorized dealer for diagnosis.

If it is determined that the condition is caused by the type of fuel used, repairs might not be covered by the vehicle warranty.

Gasoline Specifications
At a minimum, gasoline should meet ASTM specification D 4814. Some gasolines contain an octane-enhancing additive called methylcyclopentadienyl manganese tricarbonyl (MMT). We recommend against th ...

Fuels in Foreign Countries
If planning to drive in countries outside the U.S. or Canada, the proper fuel might be hard to find. Check regional auto club or fuel retail brand websites for availability in the country where d ...

Other materials:

Power Steering
Specifications Power Steering System Bleeding Note: Use clean, new power steering fluid type only. See the Maintenance and Lubrication subsection for fluid specifications. Hoses touching the frame, body or engine may cause system noise. Verify that the hoses do not touch any ot ...

Airbag Readiness Light
This light shows if there is an electrical problem with the airbag system. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module. The airbag readiness light comes on for several ...

Front Wheel Drive Shaft Replacement - Right Side
Special Tools CH-313 Slide Hammer CH-6003 Axle Shaft Remover CH-49376 Holding Wrench CH-49400 Hub Spindle Remover DT-6332 Seal Protector EN-956-1 Extension For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: To prevent personal injury and/or component ...

© 2011-2026 Copyright www.ccruze.com