Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Winter Tires

This vehicle was not, originally, equipped with winter tires. Winter tires are designed for increased traction on snow and ice-covered roads. Consider installing winter tires on the vehicle if frequent driving on snow or ice-covered roads is expected. See your dealer for details regarding winter tire availability and proper tire selection.

With winter tires, there may be decreased dry road traction, increased road noise, and shorter tread life. After changing to winter tires, be alert for changes in vehicle handling and braking.

If using winter tires: • Use tires of the same brand and tread type on all four wheel positions.

• Use only radial ply tires of the same size, load range, and speed rating as the original equipment tires.

Winter tires with the same speed rating as the original equipment tires may not be available for H, V, W, Y, and ZR speed rated tires. If winter tires with a lower speed rating are chosen, never exceed the tire's maximum speed capability.

All-Season Tires
This vehicle may come with all-season tires. These tires are designed to provide good overall performance on most road surfaces and weather conditions. Original equipment tires designed to GM' ...

Low-Profile Tires
If the vehicle has P225/45R18 size tires, they are classified as low‐profile tires. These tires are designed for very responsive driving on wet or dry pavement, however, may produce more roa ...

Other materials:

Instrument Panel Accessory Bezel Replacement
Preliminary Procedure Remove transmission control cover. Refer to Automatic or Manual Transmission Control Lever Trim Cover Replacement. Instrument Panel Accessory Bezel Screw (Qty: 4) Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (23 lb in). Instrume ...

Forward Lamp Wiring Harness Replacement
Preliminary Procedures Remove the front bumper. Refer to Front Bumper Fascia Replacement. Remove the headlamp. Refer to Headlamp Replacement. Using a scan tool, check for DTCs. Forward Lamp Wiring Harness Tip Create a work area large enough to lay out the new and old wiring ha ...

Battery Disconnect Warning
Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact ...

© 2011-2026 Copyright www.ccruze.com