The headlamps, parking lamps, taillamps, back-up lamps, and most of the interior
lamps turn on briefly when
is pressed
on the Remote Keyless Entry (RKE) transmitter.
After about 30 seconds the exterior lamps turn off, and then the dome and remaining
interior lights will dim to off. Entry lighting can be disabled manually by changing
the ignition out of the OFF position, or by pressing the RKE transmitter
button.
This feature can be changed.
Exit LightingRemoval Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to ...
Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Installation Procedure
Clean and prepare the attaching surfaces for brazing.
Apply structural adhesive to the attaching surfaces.
Position the rear bumper impact bar stud plate on the vehicle.
Verify the fit of the rear bumper impact bar stud plate
Clamp the rear bumper impact bar stud plate into ...