Chevrolet Cruze Owners Manual: Symbols
The vehicle has components and labels that use symbols instead of text. Symbols are shown along with the text describing the operation or information relating to a specific component, control, message, gauge, or indicator.
: This symbol is shown when you need
to see your owner manual for additional instructions or information.
: This symbol is shown when you need
to see a service manual for additional instructions or information.
Vehicle Symbol Chart
Here are some additional symbols that may be found on the vehicle and what they mean. For more information on the symbol, refer to the Index.
: Airbag Readiness Light
: Air Conditioning
: Antilock Brake System (ABS)
: Audio Steering Wheel Controls or OnStar®
: Brake System Warning Light
: Charging System
: Cruise Control
: Engine Coolant Temperature
: Exterior Lamps
: Fog Lamps
: Fuel Gauge
: Fuses
: Headlamp High/Low-Beam Changer
: LATCH System Child Restraints
: Malfunction Indicator Lamp
: Oil Pressure
: Power
: Remote Vehicle Start
: Safety Belt Reminders
: Tire Pressure Monitor
: Traction Control/StabiliTrak®
: Windshield Washer Fluid
Danger, Warnings, and Cautions
Warning messages found on vehicle labels and in this manual describe hazards
and what to do to avoid or reduce them.
Danger indicates a hazard with a high level of risk which will result in serious ...
In Brief
...
Other materials:
Fuel Tank Filler Pipe Housing Replacement
Preliminary Procedure
Remove rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner
Replacement.
Remove fuel tank filler door. Refer to Fuel Tank Filler Door
Replacement.
Fuel Tank Filler Door Lock Actuator
Procedure
Disconnect electrical connector.
Fuel Tank ...
Installation Procedure
Position the front end upper tie bar (1) on the vehicle.
Verify the fit of the front end upper tie bar.
Clamp the front end upper tie bar into position.
Weld seam accordingly.
Weld seam accordingly.
Grind down weld seams as needed for related panels and components.
...
Installation Procedure
Align the rear compartment floor panel.
Drill 4 mm (3/16 in) for rivets along the edges of the rear compartment
floor were you cant apply a resistance spot welder.
Clean and prepare the attaching surfaces for
spot welding and riveting.
Apply structural adhesive to all a ...
