Chevrolet Cruze Repair Manual: Floor Air Outlet Duct Replacement - Right Side (Right Hand Drive)
Removal Procedure
- Remove instrument outer trim cover -- right side. Refer to Instrument Panel Outer Trim Cover Replacement - Right Side.
- Remove instrument panel lower trim pad cover -- left side. Refer to Instrument Panel Lower Trim Pad Cover Replacement.
- Remove floor air outlet duct (1) -- right side.
Installation Procedure
- Install floor air outlet duct (1) -- right side.
- Install instrument panel lower trim pad cover -- left side. Refer to Instrument Panel Lower Trim Pad Cover Replacement.
- Install instrument outer trim cover -- right side. Refer to Instrument Panel Outer Trim Cover Replacement - Right Side.
Floor Rear Air Outlet Duct Replacement - Left Side
Preliminary Procedure
Remove front floor panel carpet. Refer to Front Floor Panel Carpet Replacement.
- Floor Rear Air Outlet Duct
Floor Rear Air Outlet Duct Replacement - Right Side
Preliminary Procedure
Remove front floor panel carpet. Refer to Front Floor Panel Carpet Replacement.
Floor Rear Air Outlet Duct
Heater and Air Conditioning Remote Control Replacement
Preliminary Procedures
Remove heater and air conditioning control. Refer to Heater and Air Conditioning Control Replacement.
Heater and Air Conditioning Remote Control
Procedure
Disconnect electrical components.
Instrument Panel Outer Air Outlet Duct Replacement
Preliminary Procedure
Remove instrument panel assembly. Refer to Instrument Panel Assembly
Replacement.
Instrument Panel Outer Air Outlet Duct Screw (Qty: 7)
Caution: Refer to Fastener Cautio ...
Heating and Air Conditioning System Description and Operation
Engine Coolant
Engine coolant is the key element of the heating system. The thermostat
controls engine operating coolant temperature. The thermostat
also creates a restriction for the cooling syst ...
Other materials:
Power Door Locks Description and Operation
Door Lock System Components
The power door lock system consists of the following components:
Door lock switch - located in the center of the instrument panel
Body control module (BCM)
Driver door latch
Passenger door latch
Left rear door latch
Right rear door latch
Door Lock System ...
Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the rear inner
wheelhouse as noted from the original panel.
Note: If the location of the original plug weld holes can not be
determined, space the plug weld holes every 40 mm (1½ in).
Clean and prepare the attaching & ...
Steering Knuckle Replacement
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle
Remove the wheel bearing and hub assembly. Refer to Front Wheel Bearing
and Hub Replacement.
Separate the outer tie rod end from the knuckle. Refer to Steering
Linkage Outer Tie R ...
