Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front End Upper Tie Bar Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove the front bumper fascia. Refer to Front  Bumper Fascia Replacement
  2. Remove the radiator support bracket. Refer to Radiator Support Bracket Replacement
  3. Remove the radiator grille reinforcement support. Refer to Radiator Grille Reinforcement Support Replacement
  4. Remove the hood primary and secondary latch. Refer to Hood Primary and Secondary Latch Replacement
  1. Headlamp and Front Bumper Fascia Mount Panel Bolt (Qty: 4) Caution: Refer to Fastener Caution in the Preface section.

    Tighten 22 N·m (17 lb ft)

  2. Front End Upper Tie Bar
Bolted Exterior Body Panels and Closures
Specifications ...

Front Fender Front Lower Bracket Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front   Bumper Fascia Replacement. Remove the headlamp. Refer to Headlamp Replacement Remove the front fender. R ...

Other materials:

Frontal SIR System Description
The frontal supplemental inflatable restraint (SIR) system consists of the following components: AIR BAG indicator located in the instrument cluster Inflatable restraint sensing and diagnostic module (SDM) Inflatable restraint passenger presence detection system Inflatable restraint Pass ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all related panels and ...

Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. There are only two reasons why the brake fluid level in the reservoir might go down: • The brake fluid level goes down because of normal brake lining wear. When new linings are in ...

© 2011-2026 Copyright www.ccruze.com