Chevrolet Cruze Repair Manual: Front Fender Front Lower Bracket Replacement
Preliminary Procedure
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
- Remove the headlamp. Refer to Headlamp Replacement
- Remove the front fender. Refer to Front Fender Replacement.
- Front Fender Bracket Bolt
Caution: Refer to Fastener Caution in the Preface section.
Tighten 9 N·m(80 lb in)
- Front Fender Front Lower Bracket
Front End Upper Tie Bar Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement
Remove the radiator support bracket. Refer to Radiator Support Bracket
Replacement
...
Hood Primary Latch Release Cable Replacement
Preliminary Procedure
Remove hood primary latch release cable handle. Refer to Hood Primary
Latch Release Cable Handle Replacement.
Remove the front bumper fascia. Refer to Front Bu ...
Other materials:
Removal Procedure
Support the radiator and condenser from above using the
condenser tabs on each side.
Remove the lower steering intermediate shaft bolt (1).
Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assemblies. Refer to Tire and Wheel Remov ...
How to Wear Safety Belts Properly
This section is only for people of adult size.
There are special things to know about safety belts and children. And there are
different rules for smaller children and infants. If a child will be riding in the
vehicle.
Follow those rules for everyone's protection.
It is very important for ...
Installation Procedure
Remove rear end upper panel extension (1) from service part.
Cut
Cut the body side inner panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioni ...
