Chevrolet Cruze Owners Manual: Infotainment System
If the vehicle is equipped with a navigation system as part of the infotainment system, use of the system may result in the storage of destinations, addresses, telephone numbers, and other trip information.
See the infotainment manual for information on stored data and for deletion instructions.
OnStar®
If the vehicle is equipped with OnStar® and has an active subscription, additional
data may be collected through the OnStar system. This includes information about
the vehicle’s operation; about c ...
Radio Frequency Identification (RFID)
RFID technology is used in some vehicles for functions such as tire pressure
monitoring and ignition system security, as well as in connection with conveniences
such as Remote Keyless Entry (RKE) ...
Other materials:
Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Right Side)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Headlamp Aiming Procedure
Open the hood.
Measure from the floor to the center of the headlamp bulb. Some
headlamps have an aim dot marked on the headlamp lens.
At the screen, measure from the floor and place the horizontal tape at
the measured distance.
Measure from the reference line on the floor to the le ...
Inflatable Restraint Seat Position Sensors - If Equipped
The inflatable restraint seat position sensor is used to determine the
proximity of a front driver or passenger seat position with respect to
the frontal air bag. The seat position sensor interfaces with the inflatable
restraint sensing and diagnostic module (SDM). The state of the
seat positi ...
