
This light comes on when the exterior lamps are in use.
Front Fog Lamp Light
Cruise Control LightInstallation Procedure
Align the body side outer panel reinforcement.
Drill 8 mm (5/16 in) for plug welding along the edges of the body side
outer panel reinforcement as noted from the original panel.
Clean and prepare the attaching surfaces
for welding.
Position the body side outer pa ...
Installation Procedure
Cut the front end upper tie bar in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of ...
Rear Compartment Lid Emblem/Nameplate Replacement (Cruze - Left Side)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...