Chevrolet Cruze Owners Manual: Warning Lights, Gauges, and Indicator
Warning lights and gauges can signal that something is wrong before it becomes serious enough to cause an expensive repair or replacement. Paying attention to the warning lights and gauges could prevent injury.
Warning lights come on when there could be a problem with a vehicle function. Some warning lights come on briefly when the engine is started to indicate they are working.
Gauges can indicate when there could be a problem with a vehicle function. Often gauges and warning lights work together to indicate a problem with the vehicle.
When one of the warning lights comes on and stays on while driving, or when one of the gauges shows there may be a problem, check the section that explains what to do. Follow this manual's advice.
Waiting to do repairs can be costly and even dangerous.
- Instrument Cluster
- Speedometer
- Odometer
- Trip Odometer
- Tachometer
- Fuel Gauge
- Engine Coolant Temperature Gauge
- Safety Belt Reminders
- Airbag Readiness Light
- Passenger Airbag Status Indicator
- Charging System Light
- Malfunction Indicator Lamp
- Brake System Warning Light
- Antilock Brake System (ABS) Warning Light
- Up-Shift Light
- Power Steering Warning Light
- Traction Off Light
- StabiliTrak® OFF Light
- Traction Control System (TCS)/StabiliTrak® Light
- Tire Pressure Light
- Engine Oil Pressure Light
- Low Fuel Warning Light
- Security Light
- Reduced Engine Power Light
- High-Beam On Light
- Front Fog Lamp Light
- Lamps On Reminder
- Cruise Control Light
- Door Ajar Light
Ashtrays
For vehicles with a removable ashtray, the ashtray can be placed into the front
console cupholders.
To open the ashtray, lift the lid of the ashtray. After using, close the lid.
To empty the ashtr ...
Instrument Cluster
English Automatic Transmission Cluster Shown, Metric Similar ...
Other materials:
Power Steering Gear Inlet Pipe/Hose Replacement
Removal Procedure
Remove front bumper fascia. Refer to Front Bumper Fascia Replacement
Remove as much power steering fluid from the remote power steering fluid
reservoir as possible.
Place drain pans under the vehicle as needed.
Remove power steering gear inlet hose bolt (1).
...
Front End Upper Tie Bar Support Sectioning (MAG Welding)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
W ...
Automatic Headlamp System
When it is dark enough outside and the exterior lamp control is in the automatic
position, the headlamps come on automatically.
The vehicle has a light sensor on top of the instrument panel. Make sure it is
not covered, or the headlamps will be on when they are not needed.
The system may als ...
