Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Odometer

The odometer shows how far the vehicle has been driven, in either kilometers or miles.

This vehicle has a tamper-resistant odometer. The digital odometer will read 999,999 if it is turned back.

If the vehicle needs a new odometer installed, it must be set to the mileage total of the old odometer.

If that is not possible, then it must be set at zero and a label must be put on the driver door to show the old mileage reading when the new odometer was installed.

Speedometer
The speedometer shows the vehicle's speed in either kilometers per hour (km/h) or miles per hour (mph). ...

Trip Odometer
The trip odometer can show how far the vehicle has been driven since the trip odometer was last reset. The trip odometer is accessed and reset through the Driver Information Center (DIC). ...

Other materials:

Overlap/Backing Plate Sectioning (Welding)
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Fit the service panel   to the vehicle to ensure a proper fit. Measure and mark a line at the sail panel 120 mm (4 3/4 in) from the back glass opening and 70 mm (2 3/4 in) rearward from the ...

Heated Seats
If available, the controls are on the center stack. The engine must be running to operate the heated seats. Press or to heat the driver or passenger seat cushion and seatback. Press the control once for the highest setting. With each press of the control, the heated seat will change to ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the rear bumper impact bar stud plate as noted from the original panel. Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Clean and prepare the ...

© 2011-2025 Copyright www.ccruze.com