Chevrolet Cruze Owners Manual: Power Steering Warning Light
This light comes on briefly when the ignition is turned to ON/RUN as a check to show it is working.
If it does not come on have the vehicle serviced by your dealer.
If this light stays on, or comes on while driving, the system may not be working. If this happens, see your dealer for service.
Up-Shift Light
For manual transmission vehicles, there is an up-shift light that comes on in
the lower DIC area. It shows when to shift to the next higher gear for best fuel
economy. ...
Traction Off Light
This light comes on briefly while starting the engine. If it does not, have the
vehicle serviced by your dealer. If the system is working normally, the indicator
light then turns off.
The tract ...
Other materials:
Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining
original panel. The sectioning joint should be trimmed to allow a
gap of one-and-one-half-times the metal thickness at the sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of the
serv ...
Installation Procedure
Position the front brake shield (2) and front wheel bearing/hub (1)
assembly in the steering knuckle.
Caution: Refer to Fastener Caution in the Preface section.
Install the NEW front wheel bearing/hub bolts (1).
Tighten the bearing/hub bolts (1) in 3 passes. Use the EN-45059 k ...
Metric Fasteners
This vehicle provides fastener dimensions using the metric system. Most
metric fasteners are approximate in diameter to equivalent
English fasteners. Make replacements using fasteners of the same nominal
diameter, thread pitch, and strength.
A number marking identifies the OE metric fastener ...
