This light shows if there is an electrical problem with the airbag system. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module.

The airbag readiness light comes on for several seconds when the vehicle is started. If the light does not come on then, have it fixed immediately.
WARNING
If the airbag readiness light stays on after the vehicle is started or comes on while driving, it means the airbag system might not be working properly. The airbags in the vehicle might not inflate in a crash, or they could even inflate without a crash. To help avoid injury, have the vehicle serviced right away.
If there is a problem with the airbag system, a Driver Information Center (DIC) message may also come on.
Safety Belt Reminders
Passenger Airbag Status IndicatorFront End Upper Tie Bar Support Sectioning (MAG Welding)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Collision Sectioning Warning in the Preface section.
W ...
Engine Heater
The engine heater, if available, can help in cold weather conditions at or below
−18°C (0°F) for easier starting and better fuel economy during engine warm-up. Plug
in the heater at least four hours before starting the vehicle. An internal thermostat
in the plug end of the cord will prev ...
Driver or Passenger Seat Retractor Side Belt Replacement
Warning: Refer to SIR Warning in the Preface section.
Warning: In order to prevent accidental deployment and the risk of personal
injury, do not dispose of an undeployed inflatable
restraint seat belt pretensioner as normal shop waste. Undeployed seat belt
pretensioners contain substance ...