Cruise Control
Ultrasonic Parking AssistSeat Belt Latch Stop Installation
Preliminary Procedure
Locate the hole in the seat belt webbing where the original seat belt
stop button was located.
If the original hole in the seat belt webbing is not visible, perform
the following:
If either the right or left stop button is missing use the opposing seat
...
Installation Procedure
Clean and prepare the attaching surfaces for welding.
Apply structural adhesive to the attaching surfaces.
Position the body rear end panel on the vehicle.
Verify the fit of the body rear end panel.
Clamp the body rear end panel into position.
Spot weld accordingly as no ...
Front Fog Lamp Bulb Replacement
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
Disconnect the forward lamp electrical harness connector from the fog
lamp bulb socket.
Remove the Front Bumper Fascia Opening Lower Cover. Refer to Front
Bumper Fascia Opening Lowe ...