Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Replacing Airbag System Parts after a Crash

Chevrolet Cruze Owners Manual / Seats and Restraints / Airbag System / Replacing Airbag System Parts after a Crash

WARNING

A crash can damage the airbag systems in the vehicle.

A damaged airbag system may not work properly and may not protect you and your passenger(s) in a crash, resulting in serious injury or even death. To help make sure the airbag systems are working properly after a crash, have them inspected and any necessary replacements made as soon as possible.

If an airbag inflates, you will need to replace airbag system parts. See your dealer for service.

If the airbag readiness light stays on after the vehicle is started or comes on when you are driving, the airbag system may not work properly. Have the vehicle serviced right away.

Airbag System Check
The airbag system does not need regularly scheduled maintenance or replacement. Make sure the airbag readiness light is working. Notice: If an airbag covering is damaged, opened, or broken, the air ...

Child Restraints
...

Other materials:

Antilock Brake System (ABS)
This vehicle has the Antilock Brake System (ABS), an advanced electronic braking system that helps prevent a braking skid. When the vehicle begins to drive away, ABS checks itself. A momentary motor or clicking noise might be heard while this test is going on, and it might even be noticed that ...

Hood Primary Latch Release Cable Handle Replacement
Preliminary Procedure Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement. Hood Primary Latch Release Cable Handle Procedure Pull down the hood primary latch  release cable handle. To release the handle, pull down the cable and unhook ...

Rear Compartment Lid Emblem/Nameplate Replacement (Chevrolet)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2011-2026 Copyright www.ccruze.com